STRUCTURAL STEEL ANGLES CONFIGURATION

Main Configuration Dialog
Detailer Commands
Strct Stl Angles

Configuration dialog:

Click on an area of the dialog below to go to the description for that area:

The button keeps changes made and closes the dialog.

The button discards changes made and closes the dialog.

The button brings you to this web page for help during the command (without canceling).

Breakdown of configuration options

Color and Lineweight for Angles

Command affected:  ANGSEC

Select the color and lineweight for the outline of the angle section. (how to select colors) If you are using AutoCAD® Release 14 or earlier the lineweight value will have no effect, but we encourage you to set it so you won't have to later when you upgrade.

Back to top

Scale Factor to Omit Hatching

Command affected:  ANGSEC

This value controls the scale factor that is the cut off for whether the tile is hatched. If the drawing's scale factor is below this number the hatch will be drawn. If it is above this number it will not be drawn. If you don't want the hatch to be drawn no matter what the scale of the drawing, enter 0.00 (zero). How to figure the scale factor.

Back to top

Hatch Pattern

Command affected:  ANGSEC

Select the hatch pattern for the angle section's fill.

Back to top

Color and Lineweight for hatch

Command affected:  ANGSEC

Select the color and lineweight for the hatch fill.

Back to top

Scale Factor for Hatch

Command affected:  ANGSEC

Enter the scale factor that you would like to use for the above hatch pattern. If you would like to have the hatch pattern scale with the scale of the drawing (recommended) check the "Adjust" box. This helps maintain a uniformity in details no matter what the scale. The scale factor entered should be the value you would use if the drawing were full size.

Back to top