DETAILER COMMAND CONFIGURATION
 Main
Configuration Dialog
 Detailer Commands
Configuration dialog:
Click on an area of the dialog below to go to the description for that area:
The 
button keeps changes made and takes you back to the Main
Configuration Dialog. The
button discards changes made and takes you back to the Main
Configuration Dialog. The
 button
brings you to this web page for help during the command (without canceling).
Breakdown of configuration options
Commands affected: ACTILE,
ANGSEC, BATTS,
BOLTS, BRICK,
CCHAN, CMU,
DIMLUMB, DRJAMB,
EIFS, FURCHAN,
GLULAM, GYPBD,
IJOIST, LVLBEAM,
MTLDECK, NAIL,
OPENWEB, PARTBD,
PLYWD, RNDTUBE,
SCREW, SCREWC,
SOUNDBD, SQRTUBE,
STAIRSECT, STLSTUD,
TGDECK, WDFLNG
|
Note: The commands shown in this
image and the images below have been taken from the Architectural Symbols set of
commands. The list of commands shown will match those listed in the
"Commands affected" list above.
Choose the layer control method you would like to use from the choices
listed. You may create all new objects on whichever layer is
current at the time or you may assign a layer to each of the commands. To
assign layers to each of the commands select "Assign layers...to
use" as shown above and then click on a command name from the list in the
box (scroll down for more as needed). The following dialog will appear:
Edit the layer properties for the command selected as needed and press
"OK" to save them.
For those with the APS Layer Control System
component loaded
If you have either the complete APS system or have the Layer Control system
component loaded you may also use
layer types for your layer control.
To use layer
types select "Assign layers using layer types" like shown
above then select a command from the list in the box (scroll down as
needed). The following dialog will appear:
Choose a layer type from your list of layer types like shown here at
left.
There are two ways to use
layer types: "Single Layer Assignment" or with "Layer
Schemes". Set which of these types of layer control methods you would like to
use in the Layer Control
Configuration dialog.
|
|
