WOOD STAIR SECTION CONFIGURATION
 Main
Configuration Dialog
 Detailer
Commands
 Wood Stair
Sections
Configuration dialog:
Click on an area of the dialog below to go to the description for that area:
The 
button keeps changes made and closes the dialog. The
button discards changes made and closes the dialog. The
 button
brings you to this web page for help during the command (without canceling).
Breakdown of configuration options
Command affected: STAIRSECT
Stringer depth - Enter the depth of the
stair stringer.
Show topmost kick board - Check this box if you would like the top kick board
to be drawn.
Tread thickness - Enter the thickness for
the stair treads.
Nosing overhang - Enter the distance you
would like the tread to stick out over the kick board.
Kick thickness - Enter the thickness for
the kick board.
Command affected: STAIRSECT
This value controls the scale factor that is the "cut off" for whether
the hatch below is used. If the drawing's scale factor is below or equal to this number the hatch will be
drawn. If it is above this number it will not be drawn. If you don't want
hatch to be drawn no matter what the scale of the drawing enter 0 (zero). How
to figure the scale factor.
Command affected: STAIRSECT
Select the hatch pattern for the fill.
Command affected: STAIRSECT
Select the color and lineweight for the hatch fill (How
to select colors). If you are using release 14 or earlier the
lineweight value will have no effect now, but we encourage you to set it so you
won't have to later when you upgrade.
Command affected: STAIRSECT
Enter the scale factor that you would like to use for the above hatch
pattern. If you would like to have the hatch pattern scale with the scale of the
drawing (recommended) check the "Adjust" box. This helps maintain a
uniformity in details no matter what the scale. When adjusting the scale factor
with the drawing's scale, the value entered should
be the value you would use if the drawing were full size (scale factor of 1.0).
| 
