RGNLAYR . User's Manual Getting Started Setup & Configuration Documentation Sales Support Software Support Troubleshooting

Keyboard shortcut: RL
Toolbar button:
Compatible with AutoCAD Versions: 2000, 2000i, 2002, 2004, 2005, 2006, 2007, 2008, 2009, 2010

REGEN LAYER

This command regenerates all of the objects on a single layer without regenerating the entire drawing. The layer to regen can be selected in a variety of ways. 

User configurable options: none

Known limitations:

• None reported. If there is something this command will not do that you think it should please let us know.

Alternate uses:

• None reported. If you have an alternate use for this command submit it here.

SAMPLE RGNLAYR COMMAND SYNTAX:

Command:
Command: RL
Command: RGNLAYR

Type layer, select from screen menu, pick on an object, or <Enter> to REGEN current Layer <A-WALL-INTR-01>:

Entering the layer name:

[Select from screen menu or pull-down] If you are using layer schemes you may select the layer from either the screen menu (shown at left) or from the "Layers" pull-down (shown at right). For more on using the screen menu or pull-down for layer control see Using layer schemes. If for some reason the layer selected from either of these lists does not exist it will be created with all the correct layer properties. Note: the layer names shown in both the screen menu and the pull down are abbreviations of the actual layer name. These abbreviations as well as the full layer name are defined in a layer scheme and can be edited using the SCHEMEDIT command. To configure how layers are displayed on your screen when using layer schemes see the Layer scheme control settings portion of the Layer Control section of the APS Configuration Utility.  [Pick on an object] Place your crosshairs on an object and pick. The layer that the object is on will be selected. Note: if the object you select is part of a block or an XREF the layer of the block or XREF will be selected even if the object selected resides on another layer inside the block/XREF. [Type layer] Obviously you can also just type in the layer name. [Press <Enter> or <Space>] Press <Enter> or <Space> and the objects will be changed to the current layer. In the example prompt above that would be the A-WALL-INTR-01 layer.

-- the objects on the layer selected will be regenerated --

Solutions to common questions and problems with this command

Related Commands

CHLAYR  Command to change the layer of objects with several methods for entering new layer name.

FZLYR  Command to freeze layers with several methods for entering layer names.

LAYRISO  Command to isolate layers with several methods for entering layer names.

LAYRLOCK Command to lock layers with several methods for entering layer names.

LAYROFF Command to turn layers off with several methods for entering layer names.

LAYRON  Command to turn layers on with several methods for entering layer names.

LAYRSET  Command to set current layer with several methods for entering layer name.

LAYRUNLOCK Command to unlock layers with several methods for entering layer names.

Is there anything that you find confusing or difficult? Please let us know so we can help! © Copyright 2006 KLH Software, Inc. All rights reserved. Reproduction or copying of content or images is prohibited. Legal Notices and Trademarks | Privacy Policy | Contact KLH Software Autodesk, AutoCAD, AutoCAD Architectural Desktop, AutoLISP, and Visual LISP are either registered trademarks or trademarks of Autodesk, Inc., in the USA and/or other countries. All other brand names, product names, or trademarks belong to their respective holders.