Keyboard shortcut: none
Toolbar button:
Compatible with AutoCAD Versions: 2000, 2000i, 2002, 2004, 2005, 2006, 2007, 2008, 2009, 2010

ROTATE CROSSHAIRS 45 DEGREES

Crosshair rotation toggle. Press once to rotate to 45 degrees and again to go back to 0 degrees. Intended for when a lot of dimensions need to be at a 45 degree angle but is handy for anytime for working on an area that is rotated 45 degrees.

User configurable options: none

Layers:

• Not applicable

Known limitations:

• This command modifies the UCS. Using this command when the UCS set to anything other than "World" may produce undesirable results.

• Submit a limitation not listed.

Alternate uses:

• None reported. If you have an alternate use for this command submit it here.

SAMPLE ROT45 COMMAND SYNTAX:

Command:
Command: ROT45

--the crosshairs in your drawing are rotated to 45 degrees--

Work on the area that is rotated 45 degrees and when done...

Command:
Command: ROT45

--the crosshairs in your drawing are rotated to back to 0 degrees--

 

Solutions to common questions and problems with this command

Related Commands

DALIGN  Command to replace the AutoCAD DIMALIGNED command.

DANGULAR  Command to replace the AutoCAD DIMANGULAR command.

DCON   Command to replace the AutoCAD DIMCONTINUE command.

DDIAM   Command to replace the AutoCAD DIMDIAMETER command.

DHORIZ   Command to replace the AutoCAD DIMHORIZONTAL command.

DLINEAR   Command to replace the AutoCAD DIMLINEAR command.

DRADIUS   Command to replace the AutoCAD DIMRADIUS command.

DROTATED   Command to replace the AutoCAD DIMROTATED command.

DVERT   Command to replace the AutoCAD DIMVERTICAL command.

QDIMENSION   Command to replace the AutoCAD QDIM command.