	TOILET Translate

Keyboard shortcut: none
Toolbar button:
Compatible with AutoCAD Versions: 13, 14, 2000, 2000i, 2002, 2004, 2005, 2006, 2007, 2008

TOILET

This command inserts a toilet block either offset from a point or centered on a wall.

User configurable options:

Toilet block to insert
Text for the note or leave blank for none
The text style and size used for the note is the same as for "Note and leader text" - see the Text-Leaders section of the APS Configuration Utility.

See "TOILET" Command in the Floor Plan Cmds section of the APS Configuration Utility.

Layers:

If you are using "No Layer Control" the toilet and notation will be inserted on whatever layer is current. See the Layer Control section of the APS Configuration Utility.

The default layer type for the toilet is "Plumbing Fixtures" and the default layer type for the notation is "Notes & Leaders".
- If you are using "Direct Layer Assignment" the layer name is assigned to this layer type in the Layer assignments portion of the Layer Control section of the APS-CONFIG command.
- If you are using "Layer Schemes" the layer name is assigned to this layer type in the Assigning Layer Names to Layer Types portion of the SCHEMEDIT command.
The layer type for this command can be changed in the Assigning Layer Types to Commands portion of the Layer Control section of the APS-CONFIG command.

Known limitations:

The toilet offset distances are limited to 1'-3" and 1'-6".
Submit a limitation not listed.

Alternate uses:

None reported. If you have an alternate use for this command submit it here.

SAMPLE TOILET COMMAND SYNTAX:

Command:
Command: TOILET

The following dialog appears:

Select the insertion method desired

[1'-3" or 1'-6" offset option]

Select corner to offset from:

Select the corner point. The endpoint and intersection snaps are added to your running object snaps if not already being used.

Select a point on the wall near where the toilet will go:

Select a point on the wall line approximately where the toilet should go. The nearest snap is added to your running object snaps if not already being used.

Side of the wall for the toilet:

Select the side of the wall for the toilet.

-the toilet and notation is inserted-

[End - 1'-3" or 1'-6" offset option]

[center option]

Select wall line to place toilet on:

Select the wall line.

Select point on side of wall for toilet:

Select the side of the wall for the toilet.

--the toilet and notation is inserted--

[End - center option]