	XCLEAN Translate

Keyboard shortcut: XCL
Toolbar button:
Compatible with AutoCAD Versions: 13, 14, 2000, 2000i, 2002, 2004, 2005, 2006, 2007, 2008

"X" WALL CLEANUP

This command cleans up where two walls cross each other. Each wall may consist of any number or combination of lines, plines and mlines and they do not need to be parallel.

User configurable options: none

Known limitations:

This command will not work on ARCs.
The relation of the outer lines of the "wall" must be 45 degrees or less to each other. (Parallel lines would be an angle of zero).
Submit a limitation not listed.

Alternate uses:

This command can be used for more than just walls, use it any time you need to clean up the crossing of two sets of lines/plines/mlines.
Submit an alternate use not listed

SAMPLE XCLEAN COMMAND SYNTAX:

Command:
Command: XCL
Command: XCLEAN

Select first point of a line crossing the FIRST set of lines/plines/mlines:

Select the first point of the line.

Second point:

Select this point.

Select second point of line crossing SECOND set of lines/plines/mlines or <Enter>/<Space> to select new start point for crossing line:

Select this final point crossing the second set of lines/plines/mlines.

If for whatever reason you can't cross the second set of lines using the second point of the first line as the first point for the second line press <Enter>/<Space> and you will be prompted to provide an alternate starting point for the second crossing line.

--the wall lines will be trimmed as necessary to form the "X" shape--