1. Close AutoCAD

If you have AutoCAD open, close it.

2. Insert the APS CD

Insert the APS installation CD. The following should appear:

followed by:

Press "Next >"

If the above dialogs do not appear then do the following:

1. Press the "Start" button and select "Run"
2. Press "Browse..." and go to the APS CD and select the "APS.exe" file, then press "Open" or "OK".
3. Press "OK" on the "Run" dialog.

3. End User License Agreement

The following end user license agreement dialog is displayed:

Read the license agreement, scroll down at the right to read it all. In order to install this software you must agree with the statements contained in it. If you agree, check "I Agree" and then click "Next >". If you do not agree press "Cancel" and the installation will exit.

4. Installation Type

Check the type of installation you performed when you first installed the APS software.

If you select "Network Installation" the "Location for Configuration File" should "remember" where yours was installed and show it here. If it does not show the correct location or if you want to change the location of your configuration file press "Browse..." and specify the location.

5. Installation Location

The existing installation should be found. Press "Next >".

6. Multiple AutoCAD and/or AutoCAD LT versions

If you have AutoCAD 14 and/or an LT version of AutoCAD you will see the above screen.

Check the installations of AutoCAD that you would like to be configured to use this version of APS.

If you have additional versions of AutoCAD loaded on your computer that you would like to set up to use with this software you may set them up manually after this installation is complete. See Setting up additional version(s) of AutoCAD to use the APS software.

7. Start Installation

If everything you have entered so far is what you want it to be press "Next >" to begin the installation of the files.

8. Install files

The files are installed.

9. Finish software installation

Once the files have been installed you will see the above dialog to let you know that the installation was successful.

Press "Finish >" and the verification of the files is complete. All program files should be restored to their original state. Custom files are unchanged but will be replaced if missing.

Back to top